首页 » Renca-Luc荧光示踪稳定表达细胞株-BioVector NTCC保藏中心

Renca-Luc荧光示踪稳定表达细胞株-BioVector NTCC保藏中心

  • 价  格:¥79835
  • 货  号:Renca-Luc
  • 产  地:北京
点击询问我要采购
 竭诚为您服务!
BioVector NTCC典型培养物保藏中心
联系人:Dr.Xu, Biovector NTCC Inc.

电话:400-800-2947 工作QQ:1843439339 (微信同号)

邮件:Biovector@163.com

手机:18901268599

地址:北京

已注册
 

Renca-Luc荧光示踪稳定表达细胞株-BioVector NTCC保藏中心
I. IntroductionHost Cell: RencaExpressed gene: LuciferaseStability: 32 passagesFreeze Medium: 90% FBS+10% DMSOCulture Medium: RPMI-1640+10%FBS+2 ug/ml puromycinMycoplasma Status: NegativeStorage: Liquid nitrogen II. Description of Host Cell LineOrganism: Mus musculus, mouseTissue: Kidney
Disease: Renal adenocarcinomaMorphology: Epithelial-likeGrowth Properties: Adherent III. Representative Data
Figure. Detect Luciferase assay by Promega Bright-Glo Luciferase Assay System..The number of Luminescence signal is 524±24(Mean±SD) onRencacells while 408194±16611(Mean±SD) on Renca-Luccells.
IV. Stablity Test
Figure. Stablity test results.Renca-Luccells showed at least 32 passage stability with similar luminescence unit.
V. Handling Procedure for Flask CulturesThe flask was seeded with cells grown and completely filled with medium at Cobioer to prevent loss of cells during shipping.1. Upon receipt visually examine the culture for macroscopic evidence of any microbial contamination.Using an inverted microscope (preferably equipped with phasecontrast optics), carefully check for any evidence of microbial contamination. Also check to determine if the majority of cells are still attached to the bottom of the flask; during shipping the cultures are sometimes handled roughly and many of the cells often detach and become suspended in the culture medium (but are still viable).2. If the cells are still attached, aseptically remove all but 5 to 10 mL of the shipping medium. The shipping medium can be saved for reuse. Incubate the cells at 37°C in a 5% CO2 in air atmosphere until they are ready to be subcultured.3. If the cells are not attached, aseptically remove the entire contents of the flask and centrifuge at 1000rpm for 5 to 10 minutes. Remove shipping medium and save. Resuspend the pelleted cells in 10 mL of this medium and add to 25 cm2 flask. Incubate at 37°C in a 5% CO2 in air atmosphere until cells are ready to be subcultured.
VI. Subculturing ProcedureVolumes are given for a 75 cm2 flask. Increase or decrease the amount of dissociation medium needed proportionally for culture vessels of other sizes.1. Remove and discard culture medium.2. Briefly rinse the cell layer with 0.25% (w/v) Trypsin0.53 mM EDTA solution to remove all traces of serum that contains trypsin inhibitor.3.Add 2.0 to 3.0 mL of Trypsin-EDTA solution to flask and observe cells under an inverted microscope until cell layer is dispersed (depend on the batch of trypsin).Note: To avoid clumping do not agitate the cells by hitting or shaking the flask while waiting for the cells to detach. Cells that are difficult to detach may be placed at 37°C to facilitate dispersal.4.Add 6.0 to 8.0 mL of complete growth medium and aspirate cells by gently pipetting.5.Add appropriate aliquots of the cell suspension to new culture vessels.6.Incubate cultures at 37°C.Subcultivation Ratio: A subcultivation ratio of 1:4 to 1:6 is recommendedMedium Renewal: 2 to 3 times per week
VII. Cryopreservation ProcedureVolumes used in this protocol are for 75 cm2 flask; proportionally reduce or increase amount of dissociation medium for culture vessels of other sizes.1. Remove and discard culture medium.2. Briefly rinse the cell layer with 0.25% (w/v) Trypsin0.53mM EDTA solution to remove all traces of serum which contains trypsin inhibitor.3. Add 2.0 to 3.0 mL of Trypsin-EDTA solution to flask and observe cells under an inverted microscope until cell layer is dispersed (usually within 1 to 10 minutes).Note: To avoid clumping do not agitate the cells by hitting or shaking the flask while waiting for the cells to detach. Cells that are difficult to detach may be placed at 37°C to facilitate dispersal.4. Add 6.0 to 8.0 mL of complete growth medium and aspirate cells by gently pipetting.5. To remove trypsin-EDTA solution, transfer cell suspension to a centrifuge tube and spin at approximately 1000rpm for 5 to10 minutes.6. Discard supernatant and resuspend cells in cryopreservation medium.7. Transfer the cells into Cryogenic Vials, 1ml/vial.8. Frozen the cells in cryogenic container
BioVector NTCC质粒载体菌种细胞蛋白抗体基因保藏中心
电话:+86-010-53513060
网址:www.biovector.net

您正在向 biovector.net  发送关于产品 Renca-Luc荧光示踪稳定表达细胞株-BioVector NTCC保藏中心 的询问

点击“立即发送”后,我们将在1个工作日内与您取得联系。